At-Fh708Sw, At-Fh712Sw, At-Fh716Sw, At-Fh724Sw, At-Fh716 In A Standalone Operation Only; Fcc Warning - Allied Telesis AT-FH708SW Installation Manual

Statements
AT-FH708SW, AT-FH712SW, AT-FH716SW, AT-FH724SW,
AT-FH716 in a Standalone Operation Only

FCC Warning

DECLARATION OF CONFORMITY
Manufacture Name:
Manufacture Address:
Manufacture Telephone:
Declares that the Product:
Model Numbers:
This product complies with FCC Part 15B, Class B Limits:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device must not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
RADIATED ENERGY
Note: This equipment has been tested and found to comply with the limits for a Class B digital device
pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with instructions, may cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on; the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes and modifications not expressly approved by the manufacturer or registrant of this
equipment can void your authority to operate this equipment under Federal Communications
Commission rules.
WARNING: This product requires only Category 3, 4, or 5 shielded twisted-pair cable for all 10 Mbps
RJ45 connections, and Category 5 shielded twisted-pair for all 100 Mbps RJ45 connections to
comply with Class B emission limits. If not used with shielded cables, this product may cause radio
interference in which case the user may be required to take adequate measures to reduce interference
levels.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel
brouilleur du Canada.
v
U.S. Federal Communications Commission
Allied Telesyn International, Corp.
960 Stewart Drive, Suite B
Sunnyvale, CA 94086 USA
408-730-0950
Dual-speed hubs
AT-FH708SW, AT-FH712SW, AT-FH716SW,
AT-FH724SW, AT-FH716
Canadian Department of Commissions