Sealing And Inflating Tyres - Volkswagen Tiguan Owner's Manual

Bedienungsanleitung < Service & Zubehör < Volkswagen Deutschland
http://www.vw-manual.co.uk/browse?7&token=deniol2172xjKhhhjJ3Pby9gS&lang=en-GB&doc=5NA012720AB&link=3&preventShowIndivisualManualMessage=true[27/10/2016 22:58:22]
Manual gearbox: select a gear Manual gearbox: selecting a gear Changing gear Manual gearbox_0 Changing gear Selecting a gear
(manual gearbox)_0 Selecting a gear Manual gearbox_0 .
Switch on the hazard warning lights In an emergency In an emergency.
Ensure that all vehicle occupants exit the vehicle and go straight to a safe place, e.g. behind the safety barrier.
Set up the warning triangle In an emergency In an emergency. Observe any legal requirements.
Check whether the puncture can be repaired with the breakdown set Breakdown set When not to use_2 The tyre sealant must not be
used:.
When towing a trailer: unhitch the trailer from the vehicle and park it properly Towing a trailer Towing Trailer Towing_0 Transporting
items Towing_0 Towing bracket see Trailer_0 .
Remove any items of luggage from the luggage compartment.
Take the breakdown set out of the luggage compartment.
Take the sticker ② from the breakdown set and stick it on the dash panel within the driver's field of vision.
Do not remove foreign objects (e.g. screws or nails) from the tyre.
WARNING
Ignoring any of the items on this important safety checklist can lead to accidents and severe injuries.
Always follow the instructions in the checklist and observe the general safety procedures.

Sealing and inflating tyres

First read and observe the introductory information and safety warnings
Sealing a tyre
Unscrew the cap from the tyre valve.
→ Fig. 279 ①
Use the valve core extractor
Shake the tyre filler bottle → Fig. 279 ⑩
Screw the filler hose → Fig. 279 ③
automatically.
Remove the sealing plug from the filler hose
Hold the bottle upside down and inject the entire contents of the tyre filler bottle into the tyre.
Remove the empty tyre filler bottle from the valve.
Use the valve core extractor → Fig. 279 ①
Inflating the tyre
Screw the tyre filler hose → Fig. 279 ⑧
Check that the bleed screw → Fig. 279 ⑥
Start the engine and let it run.
→ Fig. 279 ⑨
Insert the plug into one of the vehicle's 12-volt sockets
→ Fig. 279 ⑤
Use the on/off switch
Run the air compressor until the tyre pressure has reached 2.0 – 2.5 bar (29 – 36 psi / 200 – 250 kPa)
minutes → .
to screw the valve core out of the tyre valve. Place the core on a clean surface.
vigorously up and down several times.
tightly onto the tyre filler bottle in a clockwise direction. The plastic foil on the plug is pierced
→ Fig. 279 ③
and place the open end fully on the tyre valve.
to screw the valve core back onto the tyre valve.
of the air compressor tightly onto the tyre valve.
is closed.
→ Electrical sockets
to switch on the air compressor.
→ Introduction
.
→ . The maximum running time is 8