Instrument Cluster Operation; Operating With The Wiper Lever; Opening The Selection Menu And Selecting A Menu Or Information Display - Volkswagen Tiguan Owner's Manual

Bedienungsanleitung < Service & Zubehör < Volkswagen Deutschland
http://www.vw-manual.co.uk/browse?7&token=deniol2172xjKhhhjJ3Pby9gS&lang=en-GB&doc=5NA012720AB&link=3&preventShowIndivisualManualMessage=true[27/10/2016 22:58:22]
If the oil change service has been reset manually, the service interval display switches to a fixed service interval, even in vehicles with a flexible
oil change service.
The service message will disappear after a few seconds, when the engine is running, or when the
wiper lever or the button on the multifunction steering wheel is pressed
If the vehicle battery was disconnected for long periods in vehicles with flexible service, the system cannot calculate the time at which the
next service is due. The information shown in the service interval display may therefore be incorrect. If this is the case, please heed the
maximum permissible service intervals listed in the ⇒ Booklet Service Schedule , .

Instrument cluster operation

Introduction
This chapter contains information on the following subjects:

→ Operating with the wiper lever

→ Operating using the multifunction steering wheel
→ Button for the driver assist systems
→ Additional displays and display options
Some menu options can only be opened when the vehicle is stationary.
WARNING
Accidents and injuries can occur if the driver is distracted.
Never open the menus on the instrument cluster display while the vehicle is in motion.
After starting the engine with a discharged vehicle battery or after the battery has been changed, system settings (time, date, personal
convenience settings and programming) may have been changed or deleted. Check and correct the settings as necessary once the battery has
been sufficiently charged.
Operating with the wiper lever
Fig. 58 On the right of the steering column: buttons on the wiper lever (vehicles without multifunction steering wheel).
First read and observe the introductory information and safety warnings
The menus in the instrument cluster are operated using the buttons on the wiper lever.

Opening the selection menu and selecting a menu or information display

Switch on the ignition.
If a message or vehicle pictogram is displayed, press the
→ Menus in the instrument cluster
To display the selection menu
press and hold the rocker switch → Fig. 58
switch up or down.
→ Fig. 58 ① button on the wiper lever. You may have to press it several times.
or to return to the selection menu from another menu or information display,
② until the selection menu is displayed. To browse through the selection menu, press the rocker
→ Instrument cluster .
→ Introduction
button on the