http://www.vw-manual.co.uk/browse?7&token=deniol2172xjKhhhjJ3Pby9gS&lang=en-GB&doc=5NA012720AB&link=3&preventShowIndivisualManualMessage=true[27/10/2016 22:58:22]

Observe the separate instructions from the manufacturer of the breakdown set.

Contents of the breakdown set

Fig. 279 The breakdown set.

First read and observe the introductory information and safety warnings

The breakdown set is located underneath the floor covering in the luggage compartment. It includes the following components

Valve core extractor.

Sticker with the maximum permitted speed max. 80 km/h or max. 50 mph.

Filler hose with plug.

Air compressor.

ON/OFF switch.

Air bleed screw

Tyre pressure display

Tyre filler hose.

12-volt plug.

Tyre filler bottle with sealant.

Spare valve core.

There is a slot on the lower end of the valve insert extractor ① for the valve insert. This is required for extracting and fitting the tyre valve. This

also applies to the spare valve core ⑪.

Could also be integrated in the tyre filler hose.

Preparation

First read and observe the introductory information and safety warnings

Checklist

The following actions must always be carried out in the given order in preparation for filling a tyre

If you get a flat tyre, park your vehicle on a firm and level surface at a safe distance from the flow of traffic.

Switch on the electronic parking brake Parking and manoeuvring.

Automatic gearbox: move the selector lever to position P DSG® dual clutch gearbox.

Stop the engine and, if required, remove the vehicle key from the ignition lock Starting and stopping the engine Engine and ignition

Ignition see Engine and ignition_0 .

→ Introduction