Adding An Spll Daughter Board; Adding A Modem Card - Samsung iDCS 100 Installation Section

iDCS 100
TECHNICAL MANUAL

11.9 ADDING AN SPLL DAUGHTER BOARD

1. Check the battery switch on the MEM3 or MEM4 card and make sure it is on.
2. Turn off power to the system and unplug the power cord.
3. Install the SPLL card onto its connectors in the bottom left hand corner of the KSU
motherboard (see Figure 11–2).
4. Restore power to the system.
NOTE: The SPLL DAUGHTER BOARD is required in system to support BRI operation.

11.10 ADDING A MODEM CARD

1. Check the battery switch on the MEM3 or MEM4 card and make sure it is on.
2. Turn off the power to the system and unplug the power cord.
3. Remove the SMISC card from its slot, and lay card on a soft surface, component
side up.
4. Install the MODEM card onto its connectors on the SMISC card
NOTE: The white arrow on the MODEM card should point away from the KSU
Motherboard when SMISC card is re-inserted.
5. Re-insert SMISC card into the appropriate slot.
6. Restore power to the system.
7. Open system programming and use
8. Use MMC 724 to assign a directory number to the card, the default extension
number is 359.
MMC 806 to initialize the card.
11.4
INSTALLATION
PART 11 JUNE 2002
(see Figure 11–3).
HOME
PAGE
Table of
Contents