Samsung iDCS 100 Installation Section page 14

iDCS 100
TECHNICAL MANUAL
The -48VDC cable assembly has a male 2 pin connector on the iDCS PWR. Insert this
end of the DC cable into the battery (BATT) connector found on the iDCS PWR
Figure 2–7). Attach the other end of the DC power cable to the –48VDC power source.
WARNING: Be sure the proper polarity is observed. Equipment damage will result if
polarity is reversed. Do not connect external AC or DC power to the System
Section 4 Power Up Procedures).
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type recommended by the manufacturer. Dispose of used
batteries according to the manufacturer's instructions.
2.6
INSTALLATION
PART 2 JUNE 2002
Table of
Contents
(see
(see
HOME
PAGE