Spll Daughter Board; Modem Card; Itmc - Samsung iDCS 100 Installation Section

iDCS 100
TECHNICAL MANUAL

3.15 SPLL DAUGHTER BOARD

There are no options to select on this card. Insert the SPLL daughter board onto its
connectors in the bottom left hand corner of the KSU motherboard
Push firmly in the middle of both the connectors to ensure that it is fully inserted into
the back plane connector.

3.16 MODEM CARD

There are no options to select on this card. Install the modem card onto its connectors
on the SMISC card
connectors to ensure that it is fully inserted on to the SMISC connectors.
3.17 IP TELEPHONY MODULE (ITMC)
There are no options to select on the ITMC card and its capacity is 8 channels. The
card has eight (8) LEDs on its faceplate to indicate the status of the card. These
indications are described below. Insert the card into any universal card slot within the
main KSU (not expansion cabinet).
card ejectors to ensure the card is firmly seated into the back plane connector.
LED Name
PWR
RUN
RX
TX
SPD
L1
L2
L3
(Figure 3–14)
(see Figure 3–15). Press firmly on both corners above the
See Figure
Function
Power State
Processor Status
LAN TX State
LAN RX State
LAN Speed
Future
Future
Future
3.6
PART 3 JUNE 2002
(Figure 3–12)
(see Figure
(Figure 3–16)
3–1. Push firmly in the middle of both
Status
OFF Power is OFF
ON Power is ON
OFF Power is OFF
ON Card is booting
Flicker Normal Operation
OFF 10 MBPS
ON 100 MBPS
HOME
PAGE
INSTALLATION
Table of
Contents
3–13).