Adding A 2 X 4 Card; Adding An S4Bri Card - Samsung iDCS 100 Installation Section

iDCS 100
TECHNICAL MANUAL

11.7 ADDING A 2 X 4 CARD

1. Check the battery switch on the MEM3 or MEM4 card and make sure it is ON.
2. Turn off power to the system and unplug the power cord.
3. Insert the 2 X 4 card into an empty universal slot.
4. Restore power to the system.
5. Open system programming and use
6. Use MMC 724 to assign directory numbers to the ports on the card. The 2 X 4 card
uses the first six ports of each slot
lines and the third through sixth are the station ports.

11.8 ADDING AN S4BRI CARD

1. Check the battery switch on the MEM3 or MEM4 card and make sure it is ON.
2. Turn off power to the system and unplug the power cord.
3. Insert the card into an empty universal slot.
4. Restore power to the system.
5. Open system programming and use
6. Use MMC 724 to assign directory numbers to the ports on the card. The BRI card
uses all 8 ports of each slot
NOTE: SPLL required in system to support S4BRI operation.
KSU PORT NUMBERS
SLOT 1 SLOT 2 SLOT 3 SLOT 1 SLOT 2 SLOT 3 SLOT 4
033
034
035
036
037
038
039
040
MMC 806
(see figure 11–1).
MMC 806
(see figure 11–1).
041 049 057
042 050 058
043 051 059
044 052 060
045 053 061
046 054 062
047 055 063
048 056 064
11.3
to initialize the card.
The first two ports are the CO
to initialize the card.
EKSU PORT NUMBERS
065 073
066 074
067 075
068 076
069 077
070 078
071 079
072 080
FIGURE 11–1
INSTALLATION
PART 11 JUNE 2002
Contents
081
082
083
084
085
086
087
088
HOME
PAGE
Table of