Installing A Svmi-4 Card; System Size With A Svmi-4 Card Installed; Upgrading The Svmi-4 To Four Ports - Samsung iDCS 100 Installation Section

iDCS 100
TECHNICAL MANUAL
PART 13. INSTALLING A SVMi-4 CARD

13.1 SYSTEM SIZE WITH A SVMi-4 CARD INSTALLED

For the purposes of assigning system resources the SVMi-4 card consumes the
equivalent system capacity of 4 keysets. This means that when a SVMi-4 card is
installed in the iDCS 100 the system can now support a maximum of 52 station devices.
This capacity includes keysets, any device connected to a keyset port, SLTs and
keyset daughter boards.

13.2 UPGRADING THE SVMi-4 TO FOUR PORTS

Before it will operate in the iDCS 100, the SVMi-4 must be upgraded to four ports as
follows. Upgrading the SVMi-4 card basically means installing an upgrade key into its
dedicated socket.
The first thing you should do before proceeding is to discharge any static electricity
you may have gathered by touching a ground point such as the cover of the KSU
Power Supply. When you have done this then lay the SVMi-4 card face up on a non-
conductive surface.
Position the upgrade key over the socket
one edge of the upgrade key under the spring clip and gently apply pressure until the
upgrade key seats. The SVMi-4 card can now be installed in the KSU.
Note: The upgrade key will only fit in the socket with the flat side uppermost.
(see Figure 13–1) on SVMi-4 base board with
13.1
INSTALLATION
PART 13 JUNE 2002
Contents
HOME
PAGE
Table of