Inserting And Removing Devices; Inserting The I/O Module; Figure 7: Insert I/O Module (Example); Figure 8: Snap The I/O Module Into Place (Example) - WAGO -I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-630 SSI Transmitter Interface
Pos: 23.6 /Serie 750 (WAGO-I/O-SYSTEM)/Montieren/Demontieren/Geräte einfügen und entfernen - Überschrift 2 @ 3\mod_1231768483250_21.docx @ 25950 @ 2 @ 1
4.2

Inserting and Removing Devices

Pos: 23.7 /Alle Serien (Allgemeine Module)/Wichtige Erläuterungen/Sicherheits- und sonstige Hinweise/Achtung/Achtung: Arbeiten an Geräten nur spannungsfrei durchführen! @ 6\mod_1256193963573_21.docx @ 43426 @ @ 1
Perform work on devices only if they are de-energized!
Working on energized devices can damage them. Therefore, turn off the power
supply before working on the devices.
Pos: 23.8 /Serie 750 (WAGO-I/O-SYSTEM)/Montieren/Demontieren/Busklemme einfügen @ 3\mod_1231769726703_21.docx @ 25989 @ 3 @ 1
4.2.1

Inserting the I/O Module

1. Position the I/O module so that the tongue and groove joints to the fieldbus
coupler/controller or to the previous or possibly subsequent I/O module are
engaged.

Figure 7: Insert I/O Module (Example)

2. Press the I/O module into the assembly until the I/O module snaps into the
carrier rail.

Figure 8: Snap the I/O Module into Place (Example)

With the I/O module snapped in place, the electrical connections for the data
contacts and power jumper contacts (if any) to the fieldbus coupler/controller or to
the previous or possibly subsequent I/O module are established.
Pos: 23.9 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.docx @ 21810 @ @ 1
Manual
Version 1.2.0, valid from FW/HW-Version 3A/05
Mounting 29