Setting The Receiving Pc For Direct Upload; For Windows - Ricoh RDC-i700 Operation Manual

Setting the Receiving PC for Direct Upload

This section explains the preparations and settings to be made on the PC that
will receive direct upload from the camera.
• For details of how to use the direct upload function, refer to "Uploading
Note
Directly to a Computer" and "Using the Direct Upload Function" in the
'Communication/Internet' operation manual.

For Windows

This section gives a broad outline of the preparations to be performed on the
receiving PC. For details of actual installation and setting, refer to the Windows
HELP function and the operation manual.
In addition to the [Direct Upload] software on the CD-ROM supplied, you will
need to install the [Dial-Up Server] software supplied with Windows 98 in the
receiving PC.
If standard installation of the [Direct Upload] software explained in Chapter 1
was performed, the software should already be installed in the PC.
On the other hand, the [Dial-Up Server] software is not installed by standard
Windows installation procedures. The installation method for [Dial-Up Server] is
explained in this section.
Check in advance that the modem is correctly connected and that it is possible
to access the Internet using the modem.
Important
• The PC running Windows 95 can not be used as a receiving computer
Note
for Direct Upload.
Installing the Dial-Up Server Software
This operation enables you to install the Dial-Up Server software. Have the
Windows 98 CD-ROM ready.
Important
• Installing the Dial-Up Server software can not be completed until the
Note
dial-up adapter is displayed in the Network Component window.
P.171 "Installing the Dial-Up Adapter"
• The explanations in this section use the settings for Windows 98. The
Note
settings for Windows 2000 or Windows NT 4.0 are slightly different.
Contact your nearest Ricoh service office.
148