Ricoh RDC-i700 Operation Manual page 131

D Click on [RDC-i700 Properties...].
The window for setting the camera's IP address will be displayed.
E Input the figures displayed on the camera's LCD monitor (4 figures
separated by ".").
F Click [OK].
The camera is now detected by the PC.
If you click [+] on the left of [RDC-i700], the camera's storage memory will be
displayed. You can then open, copy or delete a folder or file in the same way as
with an ordinary disk.
Normally, images are saved in [100RICOH] in the [DCIM] folder.
When disconnecting the camera wiith a PC or turning off the camera, select
[Disconnect] from the [RDC-i700] menu.
Important
• You can change the folder name in the storage memory using RDC-
Note
i700 Explorer Plug-In, but unless you change the file name based on
the DCF format, the folder will be downloaded properly by the camera.
The folder name will not be recognized by the camera unless it is 3
figures followed by 5 letters, as in [100RICOH].
• If you change a folder name on the CF card using RDC-i700 Explorer
Plug-In, or use the CF card on another camera, the folder name may
fail to be read and the stored images may fail to be downloaded.
6
129