Configuring Your Gp-Sw3000, Gp-Sw2000, Gp-Sw1000, And Gp-Sw600 - Go Power GP-SW3000 Manual

excessive power consumption requirements, reverse polarity, or use in unsuitable
climates. This is the only warranty and the company makes no other warranties, express
or implied, including warranties of merchantability and fitness for a particular purpose.
Repair or replacement is your sole remedy and Go Power! shall not be liable for damages,
whether direct, incidental, special or consequential, even if caused by negligence or other
fault.
: For more
Note
10. Configuring your GP-SW3000, GP-SW2000, GP-SW1000,
information on
power saving,
and GP-SW600
please see 5.10
and 5.11 sections.
10.1 Configuring the Dip Switches
GP-SW3000, GP-SW2000 and GP-SW1000
Switches are located on the front panel. Power saving is enabled and adjusted through dip
switches S1, S2, and S3 on the front of the inverter. To disable power saving, leave dip
: For a
Note
switches S1, S2 and S3 in the OFF or 0 position
typical North
American
* See Section 5.10 for additional information.
system, set the
Frequency to
60 Hz.
GP-SW1000 – GP-SW3000
10.2 Other Dip Switches (Professional Installer Only)
The default voltage setting for the GP-SW600, GP-SW1000, GP-SW2000 and GP-
SW3000 is 115 V AC, however all these inverters may be configured for other voltages by
a professional installer via the two red dip switches located close to the AC connection
inside each unit. The unit must be restarted in order for any changes to take effect.
Power Saving
Disable OFF
> 7 W
> 15 W OFF
> 20 W
> 28 W OFF
> 35 W
> 42 W OFF
> 50 W
0 1
S4
50 60
Freq. (Hz)
SW1 SW2
Off Off
On Off
Off On
On On
Go Power! GP-SW3000, GP-SW2000, GP-SW1000
S1 S2
OFF
ON OFF
ON
ON ON
OFF
ON OFF
ON
ON ON
GP-SW600
Dip Switch
Up
Down
VAC
100
110
115
120
and GP-SW600
Inverter Owner's Manual
S3
OFF
OFF
OFF
OFF
ON
ON
ON
ON
Freq. (Hz)
50
60
17