Warranty; Configuring Your Gp-Sw2000, Gp-Sw1000 And Gp-Sw600 - Go Power GP-SW2000 Manual

9. Warranty

We warrant this product against defects in materials and workmanship for a period of 12
months from the date of purchase and will repair or replace any defective Go Power!
Inverter when directly returned, postage prepaid, to manufacturer. This warranty will be
considered void if the unit has suffered any obvious physical damage or alteration either
internally or externally and does not cover damage arising from improper use such as
plugging the unit into an unsuitable power sources, attempting to operate products with
excessive power consumption requirements, reverse polarity, or use in unsuitable
climates.
This is the only warranty and the company makes no other warranties, express or implied,
including warranties of merchantability and fitness for a particular purpose. Repair or
replacement is your sole remedy and Go Power! shall not be liable for damages, whether
direct, incidental, special or consequential, even if caused by negligence or other fault.
10. Configuring your GP-SW2000, GP-SW1000, and GP-
Note
: For more
information on
power saving,
10.1 Configuring the Dip Switches
please see 5.10
Switches are located on the front panel.
and 5.11 sections.
GP-SW2000 and GP-SW1000
Power saving is enabled and adjusted through dip switches S1, S2, and S3 on the front of
the inverter. To disable power saving, leave dip switches S1, S2 and S3 in the OFF or 0
Note
: For a
position
typical North
American
* See Section 5.10 for additional information.
system, set the
Frequency to
60 Hz.
GP-SW2000 – GP-SW2000
10.2 Other Dip Switches (Professional Installer Only)
The default voltage setting for the GP-SW600, GP-SW1000, and GP-SW2000 is
115 V AC, however all these inverters may be configured for other voltages by a
professional installer via the two red dip switches located close to the AC connection
inside each unit. The unit must be restarted in order for any changes to take effect.
Go Power! GP-SW2000, GP-SW1000 and GP-SW600
SW600
Power Saving
Disable OFF
> 7 W
> 15 W OFF
> 20 W
> 28 W OFF
> 35 W
> 42 W OFF
> 50 W
S4 0 1
Freq. (Hz) 50 60
SW1 SW2
Off Off
On Off
Off On
On On
S1 S2
OFF
ON OFF
ON
ON ON
OFF
ON OFF
ON
ON ON
GP-SW600
Dip Switch
Up
Down
VAC
100
110
115
120
Inverter Owner's Manual
S3
OFF
OFF
OFF
OFF
ON
ON
ON
ON
Freq. (Hz)
50
60
16