Loading The Battery - Ricoh CAMERA RDC-i500 Operation Manual

Ricoh camera operation manual rdc-i500
Hide thumbs Also See for CAMERA RDC-i500:
Table of Contents

Advertisement

Loading the Battery

Load the rechargeable lithium ion battery (DB-20L) to operate the camera.
Important
• When using the camera for the first time, be sure to charge the battery.
Note
(The battery is not charged when the camera leaves the factory.)
P.15 "Charging the Battery"
A Check that the camera is turned off,
and then open the battery cover by
pressing the catch and sliding it in
the direction shown.
• P.24 "Turning On/Off the Camera"
See
B Load the battery.
Important
• Do not bring metallic objects into
Note
contact with the battery contact
surfaces or electrical connections.
Electrostatic damage could result.
C Close the battery cover.
Close the battery cover until it clicks into
position.
Shooting and Playback Guidelines
The table below gives the approximate recording and playback times that are
available, as measured under the following test conditions.
[Test conditions]
During shooting: Shoot continuously in a recording mode (shoot at intervals of
During playback: Leave the camera continuously turned on in a playback mode
Battery Type
Lithium ion battery DB-20L
16
30 seconds, without turning the camera off in the middle, with
the flash fired 50%, at an ambient temperature of 20°C (68°F).
at an ambient temperature of 20°C (68°F).
Approximate
Recording Time
50 minutes
Approximate
Playback Time
60 minutes
(fully charged)

Advertisement

Table of Contents
loading

Table of Contents