Using The Dr-3 Remote Control - Ricoh CAMERA RDC-i500 Operation Manual

Using the DR-3 Remote Control

Shooting
A Set the mode dial on the camera to a
Recording mode (
and press the
the recording destination.
B Decide the composition of the picture
and press the RELEASE button on
the remote control unit.
Press to make the subject larger, and
press to make the subject smaller.
In (Still Picture) mode
The self-timer LED will light and recording
will start after about 2 seconds.
In (Text) mode
Recording starts as soon as the RELEASE
button is pressed.
In (Voice Memo) or
Recording of the image and/or voice memo
starts when the RELEASE button is pressed.
Recording stops when the button is pressed
again.
Setting the Exposure Compensation
A Press the EV (+/–) button on the remote control unit.
B Set the exposure compensation level using the FWD ( ) or REV ( )
button and press the ENTER button on the remote control unit.
Press the RELEASE button to record the image.
Shooting in Manual Focus Mode
A Press the PROGRAM button.
Each time you press the button, the mode changes as follows: AF
SNAP ( S )
B Adjust the focus using the FWD ( ) or REV ( ) button.
Press the RELEASE button to record the image.
The indicator "MAGNIFY:FUNCTION" on the LCD monitor is not effective.
To cancel the mode setting
Press the PROGRAM button to change to the other mode.
, , or )
button to select
(Motion Picture) mode
.
RELEASE
ERASE FWD PROGRAM
EV
ENTER
REV
MULTI
MF
123
5