Error Messages; Reset Switch (P - Ricoh CAMERA RDC-i500 Operation Manual

Error Messages

If an error message is displayed on the LCD monitor or LCD panel, follow the
procedures below.
Error Message
System error occurs
Unable to change memory
Insufficient memory
Change to card
Format required
Format internal memory
Card is unavailable
Format error
UNMATCHED FILE
No file
Insufficient memory. Continue copy?
File number over. Cannot save.
Exceeded DPOF limit. Set up to 999.
Failed to create DPOF files
Failed to read DPOF files
• If the error message continues to be displayed after the above
Note
procedures have been followed, open the terminal cover and press the
reset switch (P.6) with the tip of a propelling pencil or similar object.
The settings will return to the factory default settings.
If the error message is still displayed, contact the store where
purchased or your nearest Ricoh service office.
Turn the power off and on.
Storage memory can not be switched due to some reason. Check
content of storage memory or format storage memory.
Erase unwanted files or format to obtain sufficient memory space.
Change the storage memory to card by using
Format of selected storage memory damaged. Format storage
memory.
Internal memory damaged. Format it by pressing shutter release
button.
Card damaged. Format.
Format again. If formatting is not completed, memory error
occurs. Avoid using the storage memory.
Unplayable file was selected.
No recorded files in specified folder. Change folder or select
storage memory that contains files.
Exceeded memory capacity. Perform one of following and copy
again:
• Delete unnecessary copy source,
• Delete unnecessary files in destination, or
• Format storage memory.
File number exceeded limit. Delete unnecessary files or use
another memory card.
Number of index print or number of specified print exceeded limit.
Reset DPOF settings of some files.
DPOF settings cannot be saved. Delete unnecessary files before
repeating operation. If message still appears, memory may be
damaged. Make a backup file of files saved in memory and
format memory.
DPOF settings are unreadable. Reset all DPOF settings before
repeating operation. If message still appears, memory may be
damaged. Make a backup file of files saved in madia and format
memory.
Remedy
.
131