Troubleshooting - Ricoh CAMERA RDC-i500 Operation Manual

Troubleshooting

Refer to the pointers listed below before submitting the equipment for repairs. If
the problem persists after trying the suggestions, contact your nearest Ricoh
service office.
Power Source
Problem
Power will not Battery not loaded or battery
come on exhausted
AC adapter not properly connected
Power cuts out No operation performed so auto
power off function was activated
Battery exhausted
Battery will not Battery at end of service life
charge
Battery quickly Camera operated in extremely high
consumed or low temperature environment
Camera operated in dark
environment requiring frequent use
of flash
Recording and Playback
Problem
Shutter release
Battery not loaded or battery
button pressed
exhausted
but no file
No power, or mode dial not set to
recorded
recording mode.
Shutter release button not fully
pressed (pressed halfway)
Card not formatted
No memory space on card
No space in internal memory
Card at end of service life
Self-timer on
Flash charging
Card card contact surface dirty
Cannot confirm LCD confirmation time too short
shot image
No image on No power or LCD monitor is dark
LCD monitor
128
Cause
Insert battery correctly or charge battery.
Connect correctly.
Switch camera on again.
Charge battery.
Replace with new battery.
Cause
Insert battery correctly or charge battery.
Switch on and set mode dial to recording
mode.
Press shutter release button all the way.
Format card.
Delete unnecessary files or insert new card.
Delete unnecessary files.
Insert new card.
Disengage self-timer mode.
Wait until flash LED stops blinking.
Clean with soft dry cloth.
Increase LCD confirmation time.
Switch on and press DISPLAY button to
display image on LCD monitor or press
DISPLAY button 2 seconds or more and
adjust with
Remedy
–
–
Remedy
· buttons.
Page
P.15
P.16
P.18
P.24
P.15
P.16
–
–
Page
P.15
P.16
P.24
P.25
P.47
P.35
P.20
P.103
P.103
P.20
P.62
P.48
–
P.109
P.41
P.37