Using The Remote Control; Using The Dr-4 Remote Control - Ricoh CAMERA RDC-i500 Operation Manual

Using the Remote Control

This section explains how to operate the camera using the optional remote
control units, DR-3 and DR-4 (available in the near future).
Important
• The remote control receiver is located on the front of the camera. Operate
Note
the remote control unit by pointing it at the remote control receiver.
• For instructions on replacing the batteries and maintaining the remote
Note
control unit, refer to the accompanying manual.
• Some procedures differ when performed on the remote control unit
and on the camera itself. Follow the instructions below to use the
remote control unit.

Using the DR-4 Remote Control

A Set the mode dial on the camera to a
recording mode (
press the
recording destination.
B Decide the composition of the picture
and press the RELEASE button on
the remote control unit.
Press to make the subject larger, and
press to make the subject smaller.
In (Still Picture) mode
The self-timer LED will light and recording
will start after about 2 seconds.
In (Text) mode
Recording starts as soon as the RELEASE
button is pressed.
In (Voice Memo) or
Recording of the image and/or voice memo
starts when the RELEASE button is pressed.
Recording stops when the button is pressed
again.
120
, , or ) and
button to select the
(Motion Picture) mode