Table of Contents
Advertisement
Jumper
Default Pos
J54
J55
J57
J58
J59
J60
6.2 User Area
There is a rectangular prototype area on the motherboard top right corner, consisting of a 0.1inch pitch
array of through-hole plated pads. Power from all the three switching regulators is readily accessible
along with GND through JP1 – JP16 next to the prototyping area. This area is ideal for the addition of
any custom circuitry.
There are four active low user LEDs D2, D3, D4 and D5, these are driven by connecting a logic 0 signal
to the corresponding pin on 0.1" header P7 (USER LEDS). The LED inputs are pulled to
VDD_HV_IO_MAIN through 10kOhm resistors.
There are 4 active high pushbutton switches SW1, SW2, SW3 and SW4 which will drive 5V onto the
respective pins on 0.1" connector P6 when pressed. The switch outputs are pulled to GND via 10kOhm.
Potentiometer RV1 can be connected to port pin PB[0] and is adjustable between GND and 5V from the
linear regulator. Power from all regulators can be connected to port pins as through J54:
• 1-2: 1.25V_SR to PB[1]
• 3-4: 3.3V_SR to PB[2]
• 5-6: 5V_SR to PB[3]
• 7-8: 5V_LR to PB[4]
The P12V rail from the 12V input is scaled to 4.3V through the voltage divider of R81 and R82 and the
scaled voltage can be connected to PB[5] via J55.
6.3 Known Issues
No known issues.
Off
Off
On
Off
Off
Off
PCB Legend
ADC_VSUP
12V (4.3V)
ENABLE
DISABLE
DISABLE
DISABLE
S32R274 EVB User Guide
Description
Connect EVB supply voltages to
analog inputs
Connect 12V (scaled to 4.3V) EVB
power to analog input
Enable 5V linear regulator
Disable 1.25V switching regulator
Disable 3.3V switching regulator
Disable 5.0V switching regulator
38
Advertisement
Table of Contents
