Connecting To A 100-Pin 0.5-Mm-Pitch Foot Pattern (Part 2) - Renesas M16C/30P User Manual

M3062PT2-EPB User's Manual

2.9.8 Connecting to a 100-pin 0.5-mm-pitch Foot Pattern (Part 2)

Here following is a procedure of connecting to a 100-pin 0.5-mm-pitch foot pattern on the user system using the M3T-
100LCC-QSD (not included). For details on the M3T-100LCC-QSD (not included), refer to its user's manual.
(1) Attach the TQPACK100SD to the user system.
(2) Attach the TQSOCKET100SDG included with the M3T-100LCC-QSD to the TQPACK100SD.
(3) Attach the M3T-100LCC-QSD to the TQSOCKET100SDG.
(4) Attach the CN2 side of the M30800T-PTC to the J4 side of the M3062PT2-EPB.
(5) Attach the M30800T-PTC to the M3T-100LCC-QSD.
Figure 2.15 Connecting to a 100-pin 0.5-mm-pitch foot pattern (Part 2)
Notes on Connecting the User System:
Take care not to attach a converter board in a wrong direction. It may cause a fatal damage to the emulator and
user system.
The connectors of the M30800T-PTC and M3T-100LCC-QSD are guaranteed for only 50 insertion/removal
iterations.
REJ10J0868-0200 Rev.2.00 January 16, 2006
M3T-FLX160-EPB
M3062PT2-EPB
CN2 side
(4)
M30800T-PTC
M3T-100LCC-QSD
(not included)
(5)
(3)
TQSOCKET100SDG
(2)
TQPACK100SD
100-pin 0.5-mm-pitch
(PLQP0100KB-A) foot pattern
(1)
No. 1 pin
User system
CAUTION
2. Setup
Page 38 of 102