Table of Contents
Advertisement
M3062PT2-EPB User's Manual
2. Setup
This chapter describes the preparation for using this product, the procedure for starting up the emulator and how to change
settings.
2.1 Flowchart of Starting Up the Emulator
The procedure for starting up the emulator is shown in Figure 2.1. For details, refer to each section hereafter. And, when the
emulator does not start up normally, refer to "5. Troubleshooting" (page 94).
Check the package components.
User registration
Install the M16C R8C PC7501 emulator
debugger.
Connect the host machine.
Connect the M3062PT2-EPB to the emulator.
Connect the power supply for the emulator.
Connect the user system.
Turning on the power supply.
Check the LED display of the emulator.
Start up the emulator debugger from the
High-performance Embedded Workshop.
Set the operating environment
of the emulator debugger.
Debug a program with various functions of
the emulator debugger
Figure 2.1 Flowchart of starting up the emulator
REJ10J0868-0200 Rev.2.00 January 16, 2006
▼
▼
▼
▼
▼
▼
▼
▼
▼
▼
▼
Refer to "1.1 Package Components" (page 13).
Refer to "User Registration" (page 11).
Install or the M16C R8C PC7501 emulator debugger.
Connect the PC7501 to the host machine with the LPT parallel
interface cable, USB interface cable or LAN interface cable.
Set the interface selection switch on the rear panel of the PC7501 to
the using interface.
Connect the M3062PT2-EPB and the M3T-FLX160-EPB of the
PC7501.
Connect a power supply for the emulator.
Connect the user system as occasion demands.
Turn ON the power to the emulator and the user system as
simultaneously as possible.
Check that system status LED, and POWER, CLOCK, RESET and
WARNING of target status LED are lighting. When the user system
is not connected, the POWER LED does not light up.
Start up the High-performance Embedded Workshop, and start up
the emulator debugger.
Set the INIT dialog box and MCU Setting dialog box of the
emulator debugger.
For how to use the High-performance Embedded Workshop and the
emulator debugger, refer to each online manual.
2. Setup
Page 20 of 102
Advertisement
Table of Contents
