Connecting The User System - Renesas Emulation Probe M306V8T-EPB User Manual

M306V8T-EPB User's Manual

2.9.1 Connecting the User System

When connecting the emulation probe to a 116-pin 0.65-mm-pitch foot pattern on the user system, follow the procedures
below.
(1) Mount the NQPACK116SB (included) to the user system.
(2) Connect the YQPACK116SB (included) to the NQPACK116SB and secure it with the YQ-Guide's.
(3) Connect M306V8T-PTC to the YQPACK116SB.
These corners are not round.
Figure 2.8 Connecting to an 116-pin 0.65-mm-pitch foot pattern
* NQPACK, YQPACK, YQSOCKET, YQ-GUIDE and HQPACK are trademarks of Tokyo Eletech Corporation.
Notes on Connecting the User System:
Take care not to attach a converter board in a wrong direction. It may cause a fatal damage to the emulator and
user system.
REJ10J0777-0100 Rev.1.00 2005.08.01
M306V8T-PTC
On-board evaluation
(3)
YQ-GUIDE(x4)
YQPACK116SB
(2) NQPACK116SB
116-pin 0.65-mm-pitch
(116P6A-A) foot patten
(1)
No.1 pin
User system
CAUTION
HQPACK116SB
(not incluede)
FLASH MCU etc.
2. Setup
Page 31 of 90