Table of Contents
Advertisement
M306V8T-EPB User's Manual
1.4 Specifications
Tables 1.5 lists the specifications of the M306V8T-EPB.
Table 1.5 Specifications of the M306V8T-EPB
Applicable MCU
Applicable MCU mode
Maxi. ROM/RAM capacity
Applicable power supply
Maximum operating frequency
Emulation memory
Basic debugging functions
Real-time trace function
Real-time RAM monitor function
Hardware break function
Execution time measurement function Time between program start and stop
C0 coverage
External trigger input/event output
Host machine interface
Power supply to emulator
Connecting the User System
(see
2.9
"Connecting
System" on page 30)
* Available to connect the host machine that supports USB 2.0.
With the USB interface, not all hardware (such as host machine, USB devices, USB hub) combination will work and
guaranteed.
REJ10J0777-0100 Rev.1.00 2005.08.01
M16C/60 Series M16C/6V Group M306V8
Single-chip mode
Memory expansion mode 16 bit bus width (Normal, Memory expansion mode 2)
Microprocessor mode 16 bit bus width (Normal, Memory expansion mode 2)
1. MCU internal flash ROM:
2. MCU internal RAM:
3. MCU internal flash OSDRAM:
4. MCU internal flash OSDROM:
Vcc1 = Vcc2 = Vcc3: 3.15--3.45 V
Power supply voltage 3.15 to 3.45 V: 16 MHz
1. Access area: Flash ROM of MCU
Max. operating frequency:
2. External area (CS3*--CS0* area) Possible to allocate up to 4 areas by 4 KB
- Maximum operating frequency (at 3.3 V) 0 wait:
- Download
- Address match break (max. 8 points)
- Software break (max. 64 points)
- Program execution/stop (allows free-run execution supporting software breaks)
- Memory reference/setting (reference/setting C-variables, run-time execution)
- Register reference/setting
- Disassemble display
- C-level debugging, etc.
- 256K-cycle bus information recordable
(Bus, external trigger, time stamp)
- 5 trace modes supported (Break/Before/About/After/Full)
- Can be recorded ON/OFF by events
- 4,096 bytes (256 bytes x16)
- Data/last access result
8 points (Execution address, bus detection, interrupt, external trigger signal)
Maximum/minimum/average execution time and pass count of specified four zones.
Count clock: Equal to MCU Clock or 16 MHz
8,192 KB (256 KB x 32 blocks)
External trigger input (MCU-dependent-voltage CMOS level x8) or event output
(break x1, event x7)
- LPT parallel (ECP, EEP, Byte/compatibility and Nibble/compatibility modes)
- USB (USB 1.1, full-speed)*
- LAN (10BASE-T)
Supplied from included AC adapter (power supply voltage: 100--240 V, 50/60 Hz)
M306V8T-PTC (pre-mounted) converter board for 116-pin 0.65-mm-pitch LQFP
the
User
(116P6A-A)
516KB (0F000h--0FFFFh, 80000h--FFFFFh)
16KB (00400h--043FFh)
4KB (08000h--08FFFh)
128KB (30000h--4FFFFh)
1--3 wait:
1. Outline
10 MHz
6 MHz
16 MHz
Page 18 of 90
Advertisement
Table of Contents
