Trace Window - Renesas Emulation Probe M306V8T-EPB User Manual

M306V8T-EPB User's Manual

3.4 Trace Window

The trace window is used to show the results of real-time trace measurements.
(1) Trace window
1. Trace window display
REJ10J0777-0100 Rev.1.00 2005.08.01
3. Usage (How to Use the Emulator Debugger)
Trace window
The trace window is used to show the results of real-time trace
measurements. It has the following four display modes:
- Bus mode
Bus information per cycle can be inspected. The contents are
displayed in order of execution paths.
- Disassemble + data access mixed mode
The executed instruction and the content of the accessed data
can be inspected together. Contents are displayed in order of
the execution paths.
- Disassemble mode
The execution paths of the executed instructions can be
inspected. The contents are displayed in order of execution
paths.
- Source mode
The execution paths of the source program can be inspected.
These modes can be switched over using the respective toolbar
buttons.
The trace window shows the measurement result when a real-
time trace measurement has finished. The trace window
remains blank until the real-time trace measurement in
progress finishes.
Page 60 of 90