Keithley 6485 Instruction Manual page 188

14-10 SCPI Reference Tables
Table 14-8
TRIGger command summary
Command
:INITiate
[:IMMediate]
:ABORt
:ARM[:SEQuence[1]]
[:LAYer[1]]
:SOURce <name>
:SOURce?
:COUNt <n>
:COUNt?
:TIMer <n>
:TIMer?
[:TCONfigure]
:DIRection <name>
:DIRection?
[:ASYNchronous]
:ILINe <NRf>
:ILINe?
:OLINe <NRf>
:OLINe?
:OUTPut <name>
:OUTPut?
:TRIGger
:CLEar
[:SEQuence[1]]
:SOURce <name>
:SOURce?
:COUNt <n>
:COUNt?
:DELay <n>
:AUTO <b>
:AUTO?
:DELay?
[:TCONfigure]
Description
Path to initiate measurement cycle(s):
Initiate one trigger cycle.
Reset trigger system (goes to idle state).
Path to configure arm layer:
Select control source; IMMediate, TIMer, BUS,
TLINk, or MANual.
Query arm control source.
Set measure count; 1 to 2500, or INF (infinite).
Query measure count.
Set timer interval; 0.001 to 99999.999 (sec).
Query timer interval.
Enable (SOURce) or disable (ACCeptor)
bypass.
Query arm source bypass.
Configure input/output triggers:
Select input trigger line; 1, 2, 3, 4, 5, or 6.
Query input trigger line.
Select output trigger line; 1, 2, 3, 4, 5, or 6.
Query output trigger line.
Output trigger (TRIGger) or not at all
(NONE).
Query output trigger status.
Trigger layer:
Clear pending input trigger immediately.
Trigger path.
Select control source; IMMediate or TLINk.
Query trigger control source.
Set measure count; 1 to 2500, or INF (infinite).
Query measure count.
Set trigger delay; 0 to 999.9999 (sec).
Enable or disable auto delay.
Query state of auto delay.
Query delay value.
Model 6485 Picoammeter Instruction Manual
Default
parameter
IMMediate
1
0.100
ACCeptor
1
2
NONE
IMMediate
1
0.0
OFF
Ref
Section SCPI
√
7
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√