Casio CT-X5000 User Manual page 79

Creating an Auto Accompaniment (User Rhythm)
5.
Select the part to be edited.
(1) Press 9 PART and confirm that the lamp to the left
of the button is lit.
(2) Use the bm number keys [1] through [8] to select the
part to be edited.
To select this part:
Percussion
Drums
Bass
Chord 1 to Chord 5
• This displays the mixer part indicator that
corresponds to the selected part to flash.
(3) Press 9 PART and confirm that the lamp to the left
of the button is unlit.
• At this point, you could copy a part in an existing
rhythm to a user area (except when the
accompaniment pattern is an intro or ending). See
"To copy an existing rhythm part for editing" (page
EN-84).
6.
Configure the tone and octave shift settings of
the part, if you want.
(1) Select the tone you want to use for part recording.
See "Selecting a Tone" (page EN-18).
• Only drum set tones can be selected for Drums
and Percussion parts. Drum set sounds cannot be
selected for the bass and the Chord 1 through
Chord 5 parts.
(2) Configure the part's octave shift setting.
While holding down dr OCTAVE, press the
ds TRANSPOSE [q] or [w] button.
(3) If there are recorded parts (the accompaniment
pattern of an existing rhythm, copied part, or part
recorded by performing the procedure up to step 10
at least once), pressing ck START/STOP here
starts looped playback of all the available recorded
parts. This means you can monitor the effects of your
settings as you configure them.
(4) If there are recorded parts, pressing the [6] (ENTER)
bm number key will play back only the notes of the
part being edited.
• This causes the mixer part indicator of the part
being edited and the level indicator above it to
flash.
When the part being edited is a drum part
• To exit the above state, press [6] (ENTER) again.
EN-78
Press this number key:
[1]
[2]
[3]
[4] to [8]
Flashing
7.
Configure playback settings of the part being
edited as desired.
• See "To configure the playback settings of a user
rhythm part" (page EN-86).
8.
Record keyboard play for the part being edited.
• See "To record keyboard play to each part" (page
EN-81).
9.
Configure the mixer settings of the part being
edited as desired.
• See "To configure mixer settings of a part being
edited" (page EN-83).
10.
Perform steps 5 through 9 for all parts.
11.
Perform steps 3 through 10 for all
accompaniment patterns.
12.
Save the edited rhythm using the procedure
under "To save a user rhythm" (page EN-85).