Casio CT-X5000 User Manual page 111

Using the MIDI Recorder to Record
■ Selecting a System Track Part
When the system track is specified as the event edit target
track, you can use the buttons below to select the part to be
edited. You can find out the selection status of each part by
checking for the indicators shown in the "Display" column of
the table.
To select this
Press this button:
part:
UPPER 1 cs REGISTRATION [7]
UPPER 2 dq UPPER LAYER
LOWER 1 dp SPLIT
dq UPPER LAYER
LOWER 2
(Long-press)
Auto
do AUTO HARMONIZE
Harmonize
Phrase Pad 1 cq PHRASE PAD [P1]
Phrase Pad 2 cq PHRASE PAD [P2]
Phrase Pad 3 cq PHRASE PAD [P3]
Phrase Pad 4 cq PHRASE PAD [P4]
• The UPPER 1 and UPPER 2 parts can be selected at the
same time. The LOWER 1 and LOWER 2 parts can be
selected at the same time. Step inputting an event while
two parts are selected will simultaneously input the same
event into both parts.
• Auto harmonize part and the parts of phrase pads 1
through 4 can only be selected individually. Selecting these
parts will cause the indicators of the other parts to
disappear.
EN-110
To input chord events using step input
1.
Perform the procedure under "To enter the
Song Editing Mode" (page EN-99).
2.
Use the [1] (V) and [3] (W) bm number keys
to display "TrkEvent", and then press [6]
Display
(ENTER).
This displays "Trk Sy"
3.
Use bn [–] and [+] or the bl dial to specify the
system track, and then press [6] (ENTER).
This displays the [EVENT] indicator.
4.
If there is no [ACCOMP] indicator displayed,
press cm ACCOMP to display it.
5.
Use the [2] (w) and [5] (q) bm number keys to
display the event within the measure from
which you want to start step input.
• The step input start point is the beginning of the
6.
Press cs REGISTRATION [1].
This displays the [STEP] indicator and enters the Step
Input Mode.
7.
If necessary, specify the chord event velocity
(keyboard touch).
• For information about how to specify the setting, see
8.
Specify the event length of the event you will
input in step 9.
• For information about how to specify the setting, see
9.
Specify the event to be input.
To input this:
Chord Event
Rest
(NonChord)
Tie* 2
*1 For details about chord fingering modes, see "Changing
Accompaniment Keyboard Settings" (page EN-48).
*2 For information about how to specify this setting, see step
8 under "To input note events using step input" (page
EN-108).
10.
Repeat steps 7 through 9 as required.
measure.
step 6 under "To input note events using step input"
(page EN-108).
step 7 under "To input note events using step input"
(page EN-108).
Perform this operation:
After specifying an event length in step 8,
use the accompaniment keyboard to
specify a chord.*
After specifying an event length in step 8,
press cs REGISTRATION [2].
After specifying the event length of a
chord to tie with the previous chord event
in step 8, press cs REGISTRATION [3].
1