Adjusting Display Contrast - Casio CT-X5000 User Manual

Preparing a Power Supply
Auto Resume
While Auto Resume is turned on, the current settings of the
items described below are retained even when power is
turned off (as long as power continues to be supplied to the
Digital Keyboard, and power is turned off normally by pressing
1P (power) or by triggering of Auto Power Off).
● Current settings of the items below
Tone (UPPER 1, LOWER 1, UPPER 2, LOWER 2),
Rhythm, Song number, Music Preset number, Tempo,
Transpose, Octave Shift, [ACCOMP] indicator displayed/
not displayed status
● On/off status of the functions below
Split, Layer, Portamento, Sustain, Auto Harmonize or
Arpeggiator, CT-X5000: Modulation/Assignable*
Mode
● Function setting* 2
(page EN-112) status
● Mixer (page EN-64) setting status
● CT-X5000: Category selection, tone and rhythm
category selection status, last selected tone/rhythm in
each tone/rhythm category
*1 When the setting configured with the following operation is
"2 Toggle": MODULATION/ASSIGNABLE (Mod/Asgn) 3
Button operation (Btn Act) (page EN-114).
*2 Including Reverb, Chorus, Delay, and other effect settings
included in the function settings.
The next time power is turned on, the Digital Keyboard is
returned to its setup state when power was last turned off.
Perform the procedure under "To configure function settings
with the bk FUNCTION button" (page EN-112) and turn on
Auto Resume: Other (Other) 3 Auto Resume (AtResume)
(page EN-117).
• Regardless of Auto Resume is on or off, the settings of the
items below, which are included in function settings (page
EN-112), are retained even when power is turned off (as
long as power continues to be supplied to the Digital
Keyboard, and power is turned off normally by pressing
1P (power) or by triggering of Auto Power Off).
Equalizer, Tuning, Registration Memory Freeze Target,
Pedal 2 type, Expression pedal calibration, Tap rhythm
start, Examination Mode, Display contrast
• Auto Resume does not restore the status of the setting
items below.
Note value setting, Phrase recording setting, Synchro
standby, Audio Mode file selection and playback state,
Local control setting.
EN-10

Adjusting Display Contrast

1.
Press bk FUNCTION.
2.
Press the [1] (V) bm number key to display
"Other".
3.
Press the [6] (ENTER) bm number key.
4.
Use the [1] (V) and [3] (W) bm number keys
1
, Part
to display "Contrast".
5.
Use bn [–] and [+] or the bl dial to change the
setting value.
6.
When the setting is the way you want, long-
press the [4] (EXIT) bm number key to exit the
setting screen.
O t h e r
Current setting value
C o n t r a s t