Playing An External Device From The Digital Keyboard; Ct-X5000: Outputting Sound From A Microphone - Casio CT-X5000 User Manual

Playing an External Device from
the Digital Keyboard
Connection requires commercially available connecting cords,
supplied by you.
• The connecting cords should have a stereo mini plug on
one end and a plug that matches the configuration of the
external device on the other end.
• Turn off the Digital Keyboard when making
connections. After connecting, turn down the Digital
Keyboard and external device volume levels whenever
turning power on or off.
• After connecting, turn on the external device and then
the Digital Keyboard.
• If notes from an external device that are played on the
Digital Keyboard sound distorted, lower the volume
setting of the external device.
fn AUDIO IN jack (Stereo mini jack (3.5mm))
Stereo mini plug
Center Cancel (Vocal Cut)
Enabling Vocal Cut cuts (mutes or minimizes) the vocal in the
sound being input from the AUDIO IN jack. Note that this
function cancels the sound in the center position of the audio,
which may (depending on how the original audio was mixed)
end up canceling something else other than the vocal part.
How vocal cut is performed depends on the sound being
input.
Perform the procedure under "To configure function settings
with the bk FUNCTION button" (page EN-112) and configure
the following setting: Other (Other) 3 Audio In Center Cancel
(AIn CCan) (page EN-117).
• Digital Keyboard built-in effects (reverb, chorus, delay,
DSP) are not applied to AUDIO IN jack input.
Portable audio player, etc.
CT-X5000: Outputting Sound from
a Microphone
You can connect a commercially available microphone* to the
MIC IN jack and output the sound from the microphone
through the Digital Keyboard's speakers.
* Use a dynamic microphone.
You can adjust the volume level of microphone input with
fm MIC VOLUME. Microphone volume control is
independent from overall keyboard volume.
fl MIC IN jack (Standard jack (6.3mm))
• Before connecting a microphone, make sure that the
Digital Keyboard and microphone are turned off.
• Before connecting, set both 2 VOLUME and fm MIC
VOLUME to low levels. Adjust volume settings to
appropriate levels after connecting the microphone.
• Microphone input is disabled during demo play.
Microphone Settings
You can use the Mixer to make individual adjustments to the
reverb, chorus, and delay effects that are applied to
microphone input.
See "Using the Mixer" (page EN-64).
Connecting to Audio Equipment
fm MIC VOLUME knob
EN-13