D.2 Functional Earth (Fe) Requirements - Anybus CompactCom 40 Network Manual

Appendix D: Technical Specification
D.1.6 Ethernet Interface
Ethernet Interface (RJ45 connectors)
The Ethernet interface 10/100Mbit, full or half duplex operation.
Pin no
4,5,7,8
6
3
2
1
Housing
D.1.7 M12 Connectors, Code D
Pin
1
2
3
4
5
(Thread)
D.2 Functional Earth (FE) Requirements
In order to ensure proper EMC behavior, the module must be properly connected to functional
earth via the FE pad/FE mechanism described in the Anybus CompactCom 40 Hardware
Design Guide. Proper EMC behavior is not guaranteed unless these FE requirements are
fulfilled.
D.3 Power Supply
D.3.1 Supply Voltage
The Anybus CompactCom 40 EtherNet/IP requires a regulated 3.3 V power source as specified
in the general Anybus CompactCom 40 Hardware Design Guide.
Anybus CompactCom 40 EtherNet/IP Network Guide
Description
Connected to chassis ground
over serial RC circuit
RD-
RD+
TD-
TD+
Cable Shield
Name Description
TXD+ Transmit positive
RXD+ Receive positive
TXD- Transmit negative
RXD- Receive negative
Shield Shield
1 8
2
5
1
4
178 (218)
3
SCM-1202-031 -EN 1.6