Anybus CompactCom 40 Network Manual page 102

CIP Objects
Instance Attributes
# Name Access
1 Status Get
2 Configura-
Get
tion
Capability
3 Configura- Get/Set
tion Control
4 Physical Link Get
Object
5 Interface Get/Set
Configura-
tion
Anybus CompactCom 40 EtherNet/IP Network Guide
Type Value
-
DWORD
-
DWORD
-
DWORD
-
Struct of:
UINT (Path 0002h
size)
Padded EPATH 20 F6 24 03h
Struct of:
UDINT (IP)
UDINT (Mask)
UDINT (GW)
UDINT
(DNS1)
UDINT
(DNS2)
STRING
(Domain)
Comments
Bit: Meaning:
(reserved, set to 0)
0–3 When set to h, attribute #5 contains valid
configuration from DHCP or non-volatile stor-
age. When set to 2h, attribute #5 contains
valid configuration from hardware settings.
Remaining values are reserved for future
use.
4 Multicast pending if set to 1.
5 Interface configuration pending if set to 1. A
new configuration will be loaded at the next
reset.
6 AcdStatus. Set to 1 if an address conflict is
detected. Address conflict detection is en-
abled/disabled in attribute #10.
7 AcdFault
8–31 (reserved, set to 0)
Bit: Meaning:
0-1: Always 0. For more information, consult the
CIP specifications.
2: If set to 1, the device is capable of acting as
a DHCP client. The bit is set to 0 if attribute
#24 (Enable DHCP Client) is disabled in the
Ethernet Host Object (F9h), p. 169
3: Always 0. For more information, consult the
CIP specifications.
4: The 'Configuration Settable'-bit reflects the
value of instance attribute #9 in the "Ether-
Net/IP Host Object (F8h)" on page 161.
5: The module is hardware configurable when
this bit is set to 1. The bit will be set if any of
the address attributes is set in the Network
Configuration Object (04h) during setup or if
attribute #6 (Hardware configurable address)
in the Application Object (FFh) is set.
6: Always 0. For more information, consult the
CIP specifications.
7: If set to 1, the device is capable of detecting
address conflicts. The bit is set to 0 if ad-
dress conflict detection is disabled in the
Ethernet Host Object, see page
8 - 31: (reserved, set to 0)
Value: Meaning
0: Configuration from non-volatile memory
2: Configuration from DHCP
-
-
Path to Ethernet Link Object, Instance #3
-
IP address
Subnet mask
Default gateway
Primary DNS
Secondary DNS
Default domain
100 (218)
169
SCM-1202-031 -EN 1.6