Deleting All Memorised Transmitters From The Memory; Locking / Unlocking Of The Radio Memory - Nice RD400 Instructions And Warnings For Installation And Use

On the NEW transmitter press and release the button slowly once
04.
Repeat the procedure for each transmitter to be memorised

7.9 - Deleting all memorised transmitters from the memory

Warning! - This procedure can ONLY be performed if the radio memory has been unlocked.
Press and hold the radio button
01.
Wait for LED L4(R) to light up then wait for it to switch off and wait for it to flash 3 times
02.
Release the button exactly during the 3rd flash
03.
If the memorisation procedure was successful, LED L4(R) on the control unit will flash 5 times

7.10 - Locking / unlocking of the radio memory

This procedure locks the memory, thus preventing the recognition and deletion of radio transmitters.
01.
Disconnect the control unit from the power supply
02.
Press and hold the radio button
03. Power the control unit again (continue holding
the button down)
04.
After 5 seconds LED L4(R) will emit 2 slow flashes: at this point release the button
(Within 5 seconds) repeatedly press and release the radio button
05.
select one of the following options:
- LED off = Deactivation of the memory lock.
- LED on = Activation of the memory lock.
Five seconds after last pressing the button, LED L4(R) will emit 2 slow flashes to signal the end
of the procedure.
Table 14 - Transmitter deletion procedure
on the control unit up to Step 02
Table 15 - Procedure for locking/unlocking the radio memory
on the control unit up to Step 03
(
(
on the control unit to
5 s L4(R)
)
( )
)
5 s L4(R)
...
English – 17