User Manual (End User Version) - Nice RD400 Instructions And Warnings For Installation And Use

This user guide should be stored and handed to all users of the automation.
WARNINGS
• Monitor the gate while it is moving and keep at a safe distance until it is fully open or closed; do not transit through it
until the gate is fully open and stationary.
• Do not let children play near the gate or with its controls.
• Keep the transmitters away from children.
• Suspend the use of the automation immediately as soon as you notice any abnormal operation (noises or jolting move-
ments); failure to follow this warning may cause serious danger and accidents.
• Do not touch moving parts.
• Regular checks must be carried out by qualified personnel according to the maintenance plan.
• Maintenance or repairs must only be carried out by qualified technical personnel.
• Send a command with the safety devices disabled:
If the safety devices do not work properly or are out of order, the gate can still be operated.
01. Command the gate with the transmitter. If the safety devices give the enable signal, the gate opens normally; otherwise, reattempt
within 3 seconds and keep the control activated.
02. After approximately 2 seconds the gate will start moving in the "man present" mode, i.e. so long as the control is kept pressed the
gate will keep moving; as soon as the control is released the gate will stop.
If the safety devices are out of order, arrange to repair the automation as soon as possible.
Unlocking and locking
The gearmotor is equipped with a mechanical system that allows for opening and closing the gate manually.
Manual operation must be performed in the case of a power outage or in the event of anomalies affecting the system.
In the event of a gearmotor fault, it is still possible to try release the motor to check whether the fault lies in the unlocking mechanism.
Maintenance operations admissable to the user
The operations that the user must carry out periodically are listed below:
• Cleaning of the surfaces of the devices: use a slightly damp (not wet) cloth. Do not use substances containing alcohol,
benzene, thinners or other flammable substances; the use of these substances may damage the devices and cause fires
or electric shocks.
• Removal of leaves and stones: disconnect the power supply before proceeding, so as to prevent anyone from moving
the gate. If a buffer battery is fitted, disconnect it.
USER GUIDE (to be handed to the end user)
the gearmotor (manual manoeuvre)
English – 25