Table of Contents
Advertisement
Table 16 -
Stand near the control unit with the two transmitters:
01.
02.
On the NEW transmitter, hold down any key for at least 8 seconds then release it.
03.
On the OLD transmitter press and release the key slowly for 3 times.
04.
On the NEW transmitter press and release the key slowly once.
Repeat the procedure for each transmitter to be memorised.
7.9 - Deleting all memorised transmitters from the memory
01.
Press and hold the radio button
02.
03.
This procedure locks the memory, thus preventing the recognition and deletion of radio transmitters.
01.
Disconnect the control unit from the power supply
02.
Press and hold the radio button
03.
Power the control unit again (continue holding the button down)
04.
05.
(Within 5 seconds) repeatedly press and release the button
select one of the following options:
- LED off = Deactivation of the memory lock.
- LED on = Activation of the memory lock.
of the procedure.
01. Shut off the mains power to the gearmotor.
02. Press and hold the Set key up to step 05.
03. Restore power to the gearmotor.
04. With the Set key still pressed, wait for the courtesy light to emit the initial flash, then:
- if the warning light stays on, the electric lock function has been programmed.
05. With the Set key still pressed, press and release (even several times) the
The warning light will switch on or off with the following meaning:
on = electric lock
off = phototest
06. Release the Set key.
18 – English
Procedure for memorising the transmitter near the control unit
wait 1 second between one step and the next.
Table 17 - Transmitter deletion procedure
on the control unit.
on the control unit up to Step 03
on the control unit to
key.
8s
3 s
3 s
(
)
(
)
(
) 5s
L4(R)
...
5s
L4(R)
SET
(
)
SET
(
)
SET
4 s
(
)
SET
Close
SET
3 s
Advertisement
Table of Contents
