Saving Energy And Paper - Lexmark MB2338 User Manual

Maintaining the printer
•
Always use the handholds on the printer to lift it.
•
Any cart used to move the printer must have a surface able to support the full footprint of the printer.
•
Any cart used to move the hardware options must have a surface able to support the dimensions of the
options.
•
Keep the printer in an upright position.
•
Avoid severe jarring movements.
•
Make sure that your fingers are not under the printer when you set it down.
•
Make sure that there is adequate clearance around the printer.
Note: Damage to the printer caused by improper moving is not covered by the printer warranty.
Shipping the printer
For shipping instructions, go to

Saving energy and paper

Configuring power save mode settings
Eco‑Mode
1
From the control panel, navigate to:
> Settings >
2
Select a setting.
Sleep mode
1
From the control panel, navigate to:
> Settings >
2
Enter the amount of time that the printer stays idle before it enters Sleep mode.
Hibernate mode
1
From the control panel, navigate to:
> Settings >
>
2
Select the amount of time before the printer enters Hibernate mode.
Notes:
•
Make sure to wake the printer from Hibernate mode before sending a print job.
•
The Embedded Web Server is disabled when the printer is in Hibernate mode.
http://support.lexmark.com
> Device > > Power Management >
> Device > > Power Management >
> Device > > Power Management >
or contact customer support.
> Eco‑Mode >
> Timeouts >
> Timeouts >
124
> Sleep Mode >
> Hibernate Timeout