Teach Procedures; Two-Point Static Background Suppression - Banner Q4X Instruction Manual

Q4X Stainless Steel Laser Sensor
Action
Four-pulse the remote input.
2. Lock or unlock the sensor buttons.
Action
Single-pulse the remote input to unlock the sensor.
Double-pulse the remote input to lock the sensor.
Triple-pulse the remote input to apply the operator
lock to the sensor

3.6 TEACH Procedures

Use the following procedures to teach the sensor.
To cancel a TEACH procedure, press TEACH for longer than 2 seconds, or hold the remote input Low for longer than 2
seconds. momentarily displays when a TEACH procedure is canceled.

3.6.1 Two-Point Static Background Suppression

Two-point TEACH sets a single switch point. The sensor sets the switch point between two taught target distances, relative
to the shifted origin location.
Press and Hold
> 2s
NOTE: The sensor must be set to
NOTE: To program the sensor using remote input, remote input must be enabled (
1. Present the target.
Method Action
Push Button
Present the first target. The sensor-to-target distance must be within
the sensor's range.
Remote Input
2. Start the TEACH mode.
16
2
Press again
1
Figure 14. Two-Point Static Background Suppression (Light Operate shown)
=
www.bannerengineering.com - Tel: 763.544.3164
Result
T T T T The sensor is ready to have the button
T T T
state defined and
Result
T
Run mode.
T T
T Run mode.
T T T
T T Run mode
3
Press again
to use the following instructions.
displays.
displays and the sensor returns to
displays and the sensor returns to
displays and the sensor returns to
5
Switch
Point
Value
4
= ).
Result
The target's measurement value
displays.