Shift The Zero Reference Location After A Teach; Input Wire Function - Banner Q4X Instruction Manual

Q4X Stainless Steel Laser Sensor

3.2.8 Shift the Zero Reference Location after a TEACH

Use this menu to select whether the sensor shifts the zero reference location based on the last TEACH process. The default
is , 0 = the end of barrel or the maximum range. This menu is not available in dual (intensity + distance) mode.
• —Shift the zero reference location to one of the taught positions with each TEACH
• —0 = the end of barrel or the maximum range, depending on the
This figure illustrates three examples of how changes to the zero and shift settings affect what distance readout is shown
on the display when in 2-pt TEACH mode. Changes to the zero setting affect the direction in which the distance increases.
Zero = Near
Shift = Off
(Default Setting)
Zero = Far
Shift = Off
Zero = Far
Shift = On

3.2.9 Input Wire Function

Use this menu to select the input wire function. The default is off, ignore all remote input pulses.
• —Ignore all remote input pulses
• —Remote TEACH input
• —Laser off when pulled low
• —Laser on when pulled low
12
0
100
=
200
=
300
mm
300
200
=
100
=
0
Display Reference
mm
200
100
=
0
=
-100
mm
Figure 12. Example Zero and Shift settings
www.bannerengineering.com - Tel: 763.544.3164
Display Reference
0
100
200
300
mm
300
200
100
0
mm
200
100
0
Display Reference
-100
mm
setting
Display Reference
50 mm
50 mm
Display Reference
50 mm
Display Reference