Communication; Address Setting For Rs485/Rs422 Communication - IDTECK FGR006 User Manual

IDTeck – FGR006 FINGERPRINT & PROXIMITY READER

5. Communication

5.1 Address Setting for RS485/RS422 Communication

There is 8bit DIP SW for address setting and it turns to 8bit binary code as below and each bit has fixed
address value, the address is calculated the sum value of each bit set to "1" position.
101-091
The communication setting is defaulted to RS422.
If you need the change of the mode of the communication, FGR006
(FGR006EX) must set on the links on the MAIN PCB.
Changing this jumper setting requires the use of a soldering iron.
CAUTION: Damage to the PCB will void warranty.
Example
13
NOTE: Address Setting
If used with a Ness – IDTeck iCON
control panel with Dual Pro software
then the address must start at 33 ((i.e 1
& 6 down)) regardless of how many
controllers you have online.
If used with a Ness – IDTeck iTDC
control panel with iTDC Pro software
then the address must start at 100. (i.e 3,
6 & 7 down) regardless of how many
controllers you have online.
If used with 3
your vender for address instructions
NOTE: To select the address switch
to "ON" switch it down.
rd
party controllers refer to
FGR006 – Version 3.0