Power-On; Note On Powering Off; Windows Gui Setup; System Requirements - FOR-A FA-1010 Operation Manual

3-2. Power-On

When the FA-1010 is powered on, all LEDs on the front panel including Alarm indicators light.
Once startup is complete, current status is indicated.

3-2-1. Note on Powering Off

Do not turn the power of the unit for at least 10 seconds whenever a setting is changed.
Otherwise the setting data may not be properly saved.

3-3. Windows GUI Setup

3-3-1. System Requirements

To install Product (software), your computer must meet the following requirements.
OS Windows® 7, 8 operating system
Professional (32/64 bit)
CPU Intel® Core™2 Duo processor
2 GHz or faster
Memory 2 GB or more
Display Resolution of 1280 x 1024pixels or higher recommended
Must be capable of full color (24-bit) display
Network port Ethernet, at least one port
100BASE-TX/1000BASE-T
Network cable 100BASE-TX:
1000BASE-T:
Software Microsoft® .NET Framework 4.0
Windows® Installer 3.1
* Mac OS is not supported.

3-3-2. Network Settings

Change the PC network settings for the connection with the FA-1010.
From the Startup menu, go to Local Area Connection > General > Internet Protocol
(TCP/IP) > General > Properties, then set the IP address and Subnet mask as shown below.
PC IP address
Subnet mask
* The default FA-1010 IP address is 192.168.0.10.
Category 5 or better
Category 6, or enhanced category 5
192.168.0.xxx (xxx is any number from 1 to 254 except for the
number set for the FA-1010 unit and the gateway number.)
255.255.255.0
14