Video Process Amplifier - FOR-A FA-1010 Operation Manual

4-2-5. Video Process Amplifier

The Video Process Amplifier page allows you to set Process Amp settings for each FS
separately.
Item Default Setting range
FS FS1
FS Link -
Item Default
Video Level 100.0%
Chroma Level 100.0%
Setup/Black Level
Hue
Unity (button)
* Chroma Level and Hue settings are ineffective if Correction Mode is set to Sepia.
In Link mode, the amount adjusted for the FS selected under FS will be applied to
other FSs. The resulting setting values of Linked FSs may differ. If the adjusted value
exceeds the upper/lower limit, the resulting setting value will be clipped at the limit. If
the FS selected under FS is not selected under FS Link, Link mode settings are
ineffective.
Allows you to select an FS for which to set Process Amp
FS1-FS10
settings.
Allows FS settings to be simultaneously adjusted.
Designate a base FS from those selected under FS Link >
FS1-FS10
FS. All other FS settings are adjusted in the same
increments as those of the base FS.
Setting range (Steps)
0.0 - 200.0% (0.1%)
0.0 - 200.0% (0.1%)
0.0% -20.0 - 100.0% (0.1%)
0.0° -179.8° - 180.0° (0.2°)
- -
IMPORTANT
26
Description
Description
Allows you to adjust the video level.
Allows you to adjust the
chrominance level.
Allows you to adjust the black level.
Allows you to adjust the Chroma
phase.
Allows you to reset all settings in this
page to default.