Hardware - Agilent Technologies 700 Series User Manual

Installation
NOTE
The signal (Intensity or SRBR) as a function of the torch viewing position will be
displayed. The highest point in the scan is identified by the software, and the
corresponding viewing position value is stored and used for all subsequent
measurements.
11 If you have an ICP-OES with an axially oriented plasma, change the setting or
'Orientation' to Vertical and click Torch Scan again. If you have an ICP-OES with
a radially oriented plasma, this step is not required.

Hardware

Your ICP-OES should be ready to operate after the Agilent field service engineer
has installed it. However, you may need to set up items such as the peristaltic
pump, nebulizer, torch or spraychamber. For instructions on how to do this, please
refer to the Help. Click Start > All Apps > ICP Expert II > ICP Expert II Help.
When the ICP Expert II Help appears, click How to > Install instrument components
to view step-by-step instructions on how to remove and install the various
instrument components.
26 Agilent 700 Series ICP Optical Emission Spectrometers User's Guide