Table of Contents
Advertisement
10.8. OFFSET RECEPTION
AR-DV10 can be easily programmed to shift the receive frequency by a preprogrammed
value.
This is useful when receiving two-frequency radio communications, such as a base station
and a mobile station or a relay station, that transmit to each other on two frequencies.
The difference between the two frequencies is the offset frequency.
Access the offset menu as follows:
1.
Press [MENU] followed by [ENT].
2.
Use [▶] to select [VFO EDIT], then press [ENT].
3.
Use [▶] to select either [OFFSET F.], then press [ENT].
4.
By rotating the dial knob, select a storage number be-
tween 00 and 39, depending on the following
scenarios:
00:
Offset is disabled
01〜19: Offset value to be configured manually
20〜39: Preset of common offset values
5.
To enter a negative value, press the [0] key to toggle
[+] to [-].
6.
Press the [.] key to select the frequency input area.
7.
Input the frequency in MHz, using the keypad numbers,
press [ENT] to validate the entry.
8.
Use [▶] to select [VFO PARAM SET], then press [ENT]
to save the selection.
10.9. REMOTE MODE
The receiver can be remotely controlled from a PC by using serial commands.
The command list can be downloaded on our website.
When the remote mode is active, on the VFO
screen, the [◉] icon is displayed on the top left of
the LCD.
However. when the MENU-TOP screen is active the
[◉] icon will be located on the top right of the LCD.
During remote control, all buttons and switches
except the red power switch and [ENT] will be
disabled.
To deactivate remote control, press [ENT].
49
Advertisement
Table of Contents
