Table of Contents
Advertisement
1 BEEP (00-15)
Beep volume level when a key is pressed, or to indicate an error.
Default is 05.
2 VOL ATT (00-15)
Limits the maximum volume level. 00 is maximum volume, 15 is the most attenuated.
For levels 06 and over, [VolATT] is displayed on screen.
Default is 05.
3 CONTRAST (00-40)
Sets the LCD contrast level.
Default is 30.
4 BACKLIGHT
Sets the LCD backlight behavior.
OFF (default)
CONT
AUTO
5 SQL.SKIP
Controls audio recording behavior.
ON (default)
OFF
6 RES.CODE
Configuration of receiver control PC commands.
ON (default)
OFF
7 PROTECT
Auto-store configuration when the receiver is switched OFF.
ON
OFF (default)
8 RF-GAIN (000-255)
Manual gain control setting. Functions only when AGC is set to [RF-G] (Manual gain). This
setting can be useful in SSB or CW to improve signal to noise ratio.
Default is 000.
(p2/2 of MENU CONFIG)
4 SYSTEM RESET
All MENU settings are returned to factory default. Memory data is retained.
5 FULL RESET
All settings are returned to factory default and all memory data is deleted.
6 FACTORY MENU
Access is restricted to AOR Service Department.
7 FIRM
Displays the firmware version.
Always OFF. Saves battery power.
Always ON. Consumes more battery.
Switches ON when some keys or controls are operated, switches OFF
automatically off after 5 seconds.
Audio is only recorded when the squelch is open.
Audio is recorded whether the squelch is open or closed.
A result code is added to the beginning of a command response.
Command responses do not feature a result code.
Configuration auto-store is OFF.
Configuration auto-store is ON.
51
Advertisement
Table of Contents
