Table of Contents
Advertisement
2.3.
LEFT SIDE
(14) POWER switch
Press the switch briefly to turn the receiver ON.
Press and hold it for 3 seconds to turn the receiver
OFF.
(15) SQL/MONI (squelch/monitor) switch
Press to enable the squelch value to be adjusted
with the DIAL. Press again to validate and save
the setting.
Press and hold this button to open the squelch
manually, to listen for weak signals. That is the
MONITOR function.
(16) microSD card slot
Lift the rubber cover to install the supplied SD card.
The SD card is used for audio recording &
playback. The card is also used to backup and
restore memories, memory banks, system & CSV
data, as well as to install firmware updates.
All rubber covers must be closed and the
battery pack installed for the receiver to be
waterproof (IPX5).
2.4.
RIGHT SIDE
(17) EARPHONES jack
(3 pin 3.5mm, mono output)
Lift the rubber cover to connect earphones. A menu
setting allows the earphone cable to act as an
antenna
for
107.99999MHz, 100kHz IF bandwidth only).
(18) DATA jack
(USB mini-B socket)
Lift the rubber cover to connect a USB cable for
command control. (No AOR software supplied.)
(19) EXT DC jack
To power the receiver from an external source,
connect either the supplied AC power adapter or
the cigarette lighter DC/DC converter.
For safety reasons, use only the supplied power
devices.
FM
Broadcast
band
(64
-
7
Advertisement
Table of Contents
