Table of Contents
Advertisement
5.
Press [MENU], then use [▶] to select [CONF], followed
by [ENT].
6.
Press [▶]until [SYS UPDATE] is displayed, then press
[ENT].
The firmware file will be automatically displayed.
If more than one firmware file is stored to the card,
select the desired file.
7.
Press [ENT] to start the update.
8.
[DO NOT POWER OFF] will be displayed during the
update. Wait approximately one minute for the update
to complete.
The receiver will reboot automatically.
The receiver is now ready for use.
56
Advertisement
Table of Contents
