Table of Contents
Advertisement
・(line 2) DMR slot selection
Only the selected slots will be decoded.
1+2
Both slots but priority on SLOT1
2+1
Both slots but priority on SLOT2
1
SLOT1 only
2
SLOT2 only
・(line 3) DMR COLOR
When set to ON, the receiver will only decode signals corresponding to the color code
number set in the (line 4) DMR COL C column. There are 16 possible color codes, from 01
to 16.
Code 00: all color codes are decoded.
・(line 5) P25 NAC
When set to ON, the receiver will only decode signals corresponding to the 3-digit
hexadecimal NAC code set in (line 6) P25 NAC C.
Each digit can hold the value 0 to 9 or A to F. That makes 4096 possible NAC codes.
Code 000: all NAC codes are decoded.
・(line 7) NXDN RAN
When set to ON, the receiver will only decode signals corresponding to the RAN code
number set in the (line 8) NXDN RAN C column. There are 63 possible color codes, from 01
to 63.
Code 00: all RAN codes are decoded.
DIGITAL SIGNAL INFO DISPLAY
When using the D-STAR mode, by default the marked
dotted area is used to display some user information.
This information display can be toggled ON or OFF as
follows:
1.
Long press on [MODE].
2.
Use [▶] to select [DIGI DISP], then press [ENT].
3.
Use [▶] to select either [DISP ON] or [DISP OFF],then
press [ENT]
48
Advertisement
Table of Contents
