Table of Contents
Advertisement
To scan a memory bank:
1.
Go to [MENU], use the [▶] button to select [SCAN] and press [ENT].
2.
Use the [▶] button to select [BANK] and press [ENT].
3.
Enter the number of the bank to be scanned using the keypad. Scan will start
immediately.
If scan stops on an inactive frequency, it means that the squelch level needs to be
•
increased, as follows:
Press the SQL/MONI switch and turn the dial selector knob clockwise until the noise
mutes and scan resumes. Press SQL/MONI again to save the squelch value.
Scan direction can be changed with the [◀] and [▶] keys.
•
To force scan to resume (even though it stopped on an active frequency), turn the
•
dial selector knob by one increment, clockwise or counter-clockwise, depending on
the scan direction.
If the modulation type is changed while scan is stopped on an active frequency, the
•
new mode will be saved into that memory channel.
To copy a scanned channel to VFO:
When scan has stopped on an active frequency of interest, this frequency channel,
•
along with all its VFO settings, can be copied to and received on VFO-Z.
•
•
•
•
•
•
•
•
To switch to memory channel browser during scan:
When scan has stopped on an active frequency of interest, you can temporarily
•
switch to memory channel browser mode.
Press [ENT] to copy
to VFO-Z
Press [ENT] to return
to scan
Press [MENU], go to [MEM]
and press [ENT].
Press [MENU], go to [SCAN]
and press [ENT].
29
Advertisement
Table of Contents
