Graco Reactor 2 H-30 Repair Manual page 47

Graco InSite InSite
Graco Graco InSite
Problem Problem Problem
No module status LEDs are
illuminated.
Has not identified GPS location
(green module status LED
flashing).
Has not established cellular
connection (orange module status
LED flashing).
Cannot view data for my unit(s) on
website.
Temperature data not displayed
on website.
Hose zone temperature data not
displayed on website.
Pressure data not displayed on
website.
334946C
Cause Cause Cause
No power to cellular module.
Still identifying location.
Unable to identify location. In a
location where GPS lock cannot
occur. Buildings and warehouses
often prevent GPS locks.
Still establishing cellular
connection.
Unable to establish cellular
connection.
Graco InSite unit has not been
activated.
Reactor temperature
measurement is not working.
The RTD or thermocouple is not
correctly installed on the hose or
is broken.
Reactor pressure measurement is
not working.
Troubleshooting
Solution Solution Solution
Turn Reactor ON.
Ensure unit is properly installed.
Verify 24V at output of the power
supply.
Make sure the M8, 4–pin to M12,
8–pin cable is installed between
cellular module and power supply.
Wait a few minutes for the unit to
identify the location.
Move system to a location with a
clear view of the sky.
Use extension cable 16X521 and
move cellular module to a location
with a clear view of the sky.
Wait a few minutes for the unit to
establish the connection.
Move system to a location with
cellular service to establish cellular
connection.
Use extension cable 16X521 and
move cellular module to a location
with a clear view of the sky.
Activate unit. See Registering
and Activating the Graco InSite
section.
See System troubleshooting
section.
See RTD or Thermocouple repair
section.
See System troubleshooting
section.
47