Controls; Control Panel; Switches; Power Switch - Thermo Scientific EASYpure II RF Operating Manual And Parts List

Power Switch

Control Panel

Thermo Scientific
Section 6
STOP
Figure 6-1. Control Panel
The power switch on the EASYpure II RF is located on the back right side
of the unit directly above the power cord receptacle.
The EASYpure II RF control panel incorporates three switches and a
digital display.

Switches

When the main power switch is on, the three switches on the control panel
function as follows:
• START: Pressing the START switch when the unit is in either the stop
("IdL") or standby ("SbY") mode will put the unit into run mode.
• STANDBY: Pressing the STANDBY switch when the unit is in either
the start (run) or stop ("IdL") mode will put the unit into a standby
mode.
• STOP: Pressing the STOP switch when the unit is in either the start
(run) or standby ("SbY") mode will put the unit into a stop ("IdL")
mode.
Note On initial power-up, the display will run the following sequence:
- Model type is scrolled -RF
- The display's LEDs will light up,
- Followed by the unit software revision,
- Finally, IdL will be displayed.

Controls

STANDBY START
EASYpure II RF 6-1